From: James Saccardo <James.Saccardo**At_Symbol_Here**CSI.CUNY.EDU>
Subject: Re: [DCHAS-L] Minus 80 move
Date: Fri, 11 May 2018 14:18:36 +0000
Reply-To: ACS Division of Chemical Health and Safety <DCHAS-L**At_Symbol_Here**PRINCETON.EDU>
Message-ID: 0F624B5E-E1FB-4BF3-BFC3-7CF84549B08E**At_Symbol_Here**csi.cuny.edu
In-Reply-To


Every -80 I ever saw has casters and just rolls away. If you have a truck with a lift gate, it should be no problem. You have to decide if the contents of the freezers must be emptied before moving the freezer. If yes, coolers and dry ice pellets should keep the contents at temperature until the freezer is in the new location.


The biggest problem you might have is getting the large freezers through smaller doorways in the building. We have had to shimmy -80 through doors with the freezer door open to reduce the size of the profile, other times we had to remove the door off the jamb to the room. Be sure you have a carpenter or maintenance personnel to remove and replace building doors as needed in case the freezers are too large to fit through the  door buck opening with the door still attached to the hinges. Removing the door from the buck gives you about another 2 inches, and sometimes that that is all that is needed.
-80's rarely have hazardous materials inside, if you don't have any radioactivity or biohazards, you might be able to keep them packed tightly in transit.
Good Luck,
James


On May 9, 2018, at 2:20 PM, Chainani, Edward Torres <echaina2**At_Symbol_Here**ILLINOIS.EDU> wrote:

Our bioengineering department will be moving to their new digs 0.3 miles away from their present location, all within campus.  Anyone willing to share their experience or some best practices on moving a number of minus 80 freezers and their contents?

Regards,
Edward Chainani


--- For more information about the DCHAS-L e-mail list, contact the Divisional membership chair at membership**At_Symbol_Here**dchas.org Follow us on Twitter **At_Symbol_Here**acsdchas

Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.