We used =BD sheets of Plexiglas with holes cut to access the valves for a pressure/vacuum manifold placed on a lab bench. The sheets were placed on both sides of the manifold and screwed to the mounting frame.
It’s a custom job but effective
Russell Vernon, Ph.D.
Director
Environmental Health & Safety
University of California, Riverside
900 University Ave
Riverside, CA 92521
www.ehs.ucr.edu
russell.vernon**At_Symbol_Here**ucr.edu
Direct (951) 827-5119
Admin (951) 827-5528
Fax (951) 827-5122
Taking a trip overseas?
Access Location Intelligence:
https://ermsp.ucop.edu/uctrip and enter your UC Net ID
From: DCHAS-L Discussion List [mailto:dchas-l**At_Symbol_Here**MED.CORNELL.EDU]
On Behalf Of Kimberly Bush
Sent: Wednesday, August 28, 2013 6:31 AM
To: DCHAS-L**At_Symbol_Here**MED.CORNELL.EDU
Subject: [DCHAS-L] Shielding for large vacuum-manifold?
[Multiposting. My apologies if you’re seeing this in duplicate.]
Has anyone seen, developed, or researched solutions for shielding laboratory-scale vacuum manifolds for pulling high vacuum on glass vessels? This would be a large (approx. 10-foot wide) glass manifold that would not be located inside
of a fume hood. We want to reduce the hazard of flying glass in the event of a glassware failure and resulting implosion.
While this particular apparatus is part of a renovation for a new research group, we have some similar equipment on our academic campus that could benefit from the same kind of solution.
Sliding panels/doors? Enclosures? Hanging blast shields? Anything like this in use?
Kimi Bush
Lab Safety Specialist
Environmental Health and Radiation Safety
University of Pennsylvania
3160 Chestnut St., Suite 400
Philadelphia, PA 19104-6287
Google Voice/cell/text: 215-360-3KIM
fax: 215-898-0140
Previous post | Top of Page | Next post